Huxley Grey Queen Wood & Button Tufted Upholstered Canopy Bed | Poster

CONNECT THE HEADBOARD PANEL TO THE LEFT AND RIGHT VERTICAL HEADBOARD POST WITH FOUR M8X40 ALLEN BOLTS , SPRING WASHERS AND FLATWASHERS . ONLY FINGER TIGHTEN THE BOLTS! ATTACH THE LOWER HEADBOARD SUPPORT TO THE HEADBOARD ASSEMBLY USING FOUR M8X50 ALLEN BOLTS , SPRING WASHERS AND FLAT WASHERS. TIGHTEN ALL BOLTS, INCLUDING THE PREVIOUS FOUR, COMPLETELY WITH THE PROVIDED ALLEN KEY. CONNECT THE FOOTBOARD PANEL TO THE LEFT AND RIGHT VERTICAL FOOTBOARD POSTS WITH FOUR M8X50 ALLEN BOLTS, SPRING WASHERS AND FLAT WASHSERS. TIGHTEN COMPLETELY WITH THE ALLEN KEY. WITH THE HELP OF A SECOND PERSON, CONNECT THE HEADBOARD AND FOOTBOARD ASSEMBLIES TO THE SIDE RAILS. CONNECT THE TOP SIDE RAIL BRACKET WITH ONE M8X20 ALLEN BOLT , SPRING WASHER AND FLAT WASHER. CONNECT THE BOTTOM SIDE RAIL BRACKET WITH ONE M8X50 ALLEN BOLT, SPRING WASHER AND FLAT WASHER. DO NOT TIGHTEN COMPLETELY UNTIL BOTH ENDS OF EACH SIDE RAIL HAVE BEEN ATTACHED. ONCE ALL PIECES ARE CONNECTED, TIGHTEN ALL BOLTS WITH THE ALLEN KEY. WITH THE USE OF A STEP LADDER CONNECT THE UPPER HEADBOARD SUPPORT AND UPPER FOOTBOARD SUPPORT THEN THE CANOPY RAILS TO THE VERTICAL HEADBOARD AND FOOTBOARD POSTS. ONCE SUPPORTS AND RAILS ARE IN PLACE, SECURE THE COMPONENTS WITH FOUR M8X50 ALLEN BOLTS, SPRING WASHERS AND FLAT WASHERS. TIGHTEN ALL BOLTS WITH THE ALLEN KEY. ATTACH THE CENTER SLAT SUPPORT LEGS TO THE CENTER SLAT SUPPORT. CONNECT THE CENTER SLAT SUPPORTASSEMBLY TO THE SLAT CLEAT ATTACHEMENT ON THE HEAD ANDFOOTBOARD, AS SHOWN IN THEILLUSTRATION. SECURE THE SLAT SUPPORTTO THE BED USING TWO WOOD SCREWS . ATTACH THE SLAT ROLL TO THE BED ASSEMBLY AS SHOWN AND SECURE WITH WOOD SCREWS. INSTRUCTIONS FOR ADJUSTING LEVELER POSITION THE BED IN YOUR SPACE AND LOCATE THE LEVELER UNDER EACH SUPPORT LEG. TURN THE LEVELER COUNTER-CLOCKWISE TO EXTEND THE LEVELER AND CLOCKWISE TO RETRACT IT. ADJUST EACH LEVELER UNTIL EACH SUPPORT LEG IS APPLY EQUAL, UPWARD PRESSURE ON THE SUPPORT SLAT.

Dust frequently with a clean, damp, lint-free cloth. Frequent dusting will remove abrasive build-up which can damage a finish over time. Occasionally use a light application of a high quality furniture polish to enhance the beauty of the finish. Avoid using oily polishes or waxes. Avoid exposing your furniture to strong sunlight. Prolonged exposure to direct sunlight can fade the finish of your furniture. Do not expose your furniture to any liquids. Never allow water to sit on your furniture. Alcohol, nail polish and perfume are also dangerous, as they can dissolve the furniture finish on contact and may require professional repairs.